Optical fibre sensors for process tomography

被引：22

作者：

Green, RG

Horbury, NM

Rahim, RA

Dickin, FJ

Naylor, BD

Pridmore, TP

机构：

[1] UNIV TEKNOL JOHOR BAHRU, FAC ELECT ENGN, DEPT CONTROL, JOHOR BAHRU, MALAYSIA

[2] UMIST, DEPT ELECT ENGN, PROC TOMOG UNIV, MANCHESTER M60 1QD, LANCS, ENGLAND

来源：

MEASUREMENT SCIENCE AND TECHNOLOGY | 1995年 / 6卷 / 12期

关键词：

D O I：

10.1088/0957-0233/6/12/008

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

This paper describes an investigation into the use of an optical fibre sensor to measure the flow of pneumatically conveyed solid particles. Typical results for the mass flow rate of dry sand versus transducer output voltage are presented for a 1 mm diameter sensor fibre. The frequency bandwidth of the sensor is determined for a range of fibre diameters and compared with the calculated response obtained using spatial filtering considerations.

引用

页码：1699 / 1704

页数：6

共 10 条

[1] DYKESTEEN E, 1990, P INT C BAS PRINCIPL
[2] GREEN RG, 1981, S FOSSIL ENERGY PROC
[3] THE SPATIAL-FILTERING EFFECT OF CAPACITANCE TRANSDUCER ELECTRODES
HAMMER, EA
GREEN, RG
[J]. JOURNAL OF PHYSICS E-SCIENTIFIC INSTRUMENTS, 1983, 16 (05): : 438 - 443
[4] TOMOGRAPHIC IMAGING OF 2-COMPONENT FLOW USING CAPACITANCE SENSORS
HUANG, SM
PLASKOWSKI, AB
XIE, CG
BECK, MS
[J]. JOURNAL OF PHYSICS E-SCIENTIFIC INSTRUMENTS, 1989, 22 (03): : 173 - 177
[5] CONDUCTIVITY AND PERMITTIVITY IMAGES FROM AN INDUCED CURRENT ELECTRICAL-IMPEDANCE TOMOGRAPHY SYSTEM
SCAIFE, JM
TOZER, RC
FREESTON, IL
[J]. IEE PROCEEDINGS-SCIENCE MEASUREMENT AND TECHNOLOGY, 1994, 141 (05) : 356 - 362
[6] DEVELOPMENT AND IMPLEMENTATION OF REAL-TIME ULTRASOUND PROCESS TOMOGRAPHY USING A TRANSPUTER NETWORK
WIEGAND, F
HOYLE, BS
[J]. PARALLEL COMPUTING, 1991, 17 (6-7) : 791 - 807
[7] Williams R.A., 1995, COAL PREP, V15, P3
[8] Williams R. A., 1995, PROCESS TOMOGRAPHY P, P101
[9] XIE CG, 1993, PROCESS TOMOGRAPHY S
[10] VELOCITY-MEASUREMENT OF PNEUMATICALLY CONVEYED SOLIDS USING ELECTRODYNAMIC SENSORS
YAN, Y
BYRNE, B
WOODHEAD, S
COULTHARD, J
[J]. MEASUREMENT SCIENCE AND TECHNOLOGY, 1995, 6 (05) : 515 - 537

← 1 →