USE OF POSITION-DEPENDENT STRESS-FREE STANDARDS FOR DIFFRACTION STRESS MEASUREMENTS

Residual stress measurements using neutron diffraction are inherently triaxial in nature due to the low absorption, and thus high penetration, of neutrons in samples of interest. This means that stress-free reference standards are required to convert measured changes in peak position to strain and stress tensors. Although a number of empirical and analytical approaches have been utilized to obtain accurate stress-free reference cell parameters, they all presume the presence of a single reference value for the material being measured. However, important cases can arise for which the local stress-free cell parameter varies from point to point. One such case, a circumferentially welded cylinder, is presented here. A method of point-to-point correction is employed, involving the sectioning of a companion piece into small cubes corresponding to the positions of stress measurement. The variations in peak position and peak breadth are presented. It is shown that accurate stress tensors can be obtained and that use of a constant value of stress-free reference cell parameter from the unaffected base metal leads to errors of up to 700 MPa in some stress tensor components. Effects on the principal stresses are also presented.