DENTAL CUTTING BEHAVIOR OF MICA-BASED AND APATITE-BASED MACHINABLE GLASS-CERAMICS

Some recently developed industrial ceramics have excellent machinability properties. The objective of this study was to evaluate the dental cutting behaviour of two machinable glass‐ceramics, mica‐containing Macor‐M® and apatite‐ and diopsidecontaining Bioram‐M®, and to compare them with the cutting behaviour of a composite resin typodont tooth enamel and bovine enamel. Weight‐load cutting tests were conducted, using a diamond point driven by an air‐turbine handpiece. While the transverse load applied on the point was varied, the handpiece speed during cutting and the volume of removal upon cutting were measured. In general, an increase in the applied load caused a decrease in cutting speed and an increase in cutting volume. However, the intensity of this trend was found to differ between four workpieces. Cutting Macor‐M® resulted in the second‐most reduced cutting speed and the maximum cutting volume. Cutting Bioram‐M® gave the least reduced cutting speed and the minimum cutting volume. It was suggested that two machinable glass‐ceramics could be employed as typodont teeth. This study may also contribute to the development of new restorative dental ceramic materials, prepared by machining. Copyright © 1990, Wiley Blackwell. All rights reserved