INFLUENCE OF HOT TOOL PARAMETERS ON HEAT-RECOVERY IN A SPACE-HEATING AND VENTILATION SYSTEM

被引:6
作者
BOJIC, M [1 ]
TRNOBRANSKY, K [1 ]
机构
[1] CZECH TECH UNIV, FAK STROJNI, CR-16607 PRAGUE 6, CZECH REPUBLIC
关键词
D O I
10.1016/0360-5442(95)00031-B
中图分类号
O414.1 [热力学];
学科分类号
摘要
A study has been carried out on heat recovery from air that ventilates a hot tool in a tool shop, The recovered heat is used to preheat air for space heating of this tool shop. Software has been used to analyze the heat-recovery efficiency and thermal comfort (TC) when the size and temperature of the hot tool are varied. An increase in hot tool size of 10% yields an energy loss of up to 2% and temperatures of the tool-shop space that are 6% higher than the TC temperature. This energy loss can be avoided if we tune the heat-recovery system (HRS) to reach TC as before. A 10% decrease of hot tool size yields at most 5% in energy saving and a tool-shop-space temperature 6% lower than the TC temperature. Further HRS tuning to provide TC will reduce energy saving. Higher or lower tool temperatures do not appreciably change the energy expenditure.
引用
收藏
页码:1075 / 1079
页数:5
相关论文
共 7 条
[1]   MATHEMATICAL-MODEL OF HEAT-RECOVERY IN A SPACE-HEATING AND VENTILATION SYSTEM [J].
BOJIC, M .
ENERGY, 1993, 18 (01) :49-61
[2]  
BOJIC M, 1991, TT1991 MECH ENG FAC
[3]  
BOJIC M, 1992, TT1092 MECH ENG FAC
[4]  
Fanger PO, 1970, P INT C MOV THERM ST
[5]  
MAHON PH, 1983, EFFICIENT ENERGY MAN
[6]  
STEPANOV VS, 1984, ANALIZ ENERGETICESKO
[7]  
Turner W.C., 1982, ENERGY MANAGEMENT HD