EFFECT OF HOLDING TIME AND SURFACE COVER IN LADLES ON LIQUID STEEL FLOW IN CONTINUOUS-CASTING TUNDISHES

Mathematical modeling of fluid flow and heat transfer of melt in a typical two-strand slab caster tundish has been done for a complete casting sequence. The complete casting sequence consists of 1 minute of tundish emptying period during the ladle transfer operation followed by 1 minute of tundish filling period by the new ladle and pouring at the normal operating level of the tundish for 46 minutes. The effect of varying ladle stream temperature conditions on the melt flow and heat transfer in the continuous casting tundish has been studied. When the ladle stream temperature decreases appreciably over the casting period, corresponding to heat loss of the melt in the ladle from the top free surface, the incoming melt temperature becomes lower than that of the melt in the bulk of the tundish after about 30 minutes from the start of teeming. This results in melt flow along the bottom of the tundish instead of the normal free surface directed flow. The ladle melt stream temperature shows little variability when the ladle has an insulated top. Corresponding to this situation, the temperature of the incoming melt remains higher than that of the melt in the bulk of the tundish and the normal free surface directed flow is maintained throughout the casting period. The product cast under such condition is expected to have a uniformly low inclusion content. The heat loss condition from the top of the ladle has been shown to be the dominant factor in determining fluid flow and heat-transfer characteristics of the melt in the tundish rather than the holding time of the melt in the ladle.