OXIDATION OF METASTABLE SINGLE-PHASE POLYCRYSTALLINE TI0.5AL0.5N FILMS - KINETICS AND MECHANISMS

Metastable single-phase, NaCl-structure, polycrystalline Ti 0.5Al0.5N alloy films have been shown to exhibit much better high-temperature (750-900 °C) oxidation resistance than polycrystalline TiN films grown under similar conditions. The Ti 0.5Al0.5N alloys, ≅3 μm thick, were deposited at temperatures between 400 and 500 °C on stainless-steel substrates by dc magnetron sputter deposition in mixed Ar+N2 discharges with an applied negative substrate bias Vs of either 0 or 150 V. Oxidation in pure O2 initially occurred at a rate that varied parabolically with time. The oxide overlayers consisted of two partially crystalline sublayers, the upper one Al-rich and the lower one Ti-rich, with no measurable N concentrations in either. Inert-marker transport experiments showed that oxidation proceeded by the simultaneous outward diffusion of Al to the oxide/vapor interface and inward diffusion of O to the oxide/nitride interface. The oxidation rate constant K increased with oxidation temperature T ox at a rate much higher than would be predicted from a simple exponential dependence due to changes in the oxide microstructure (increased crystallinity) with increasing Tox. At Tox ≥850 °C, O transport became the rate-limiting step. After oxidation times, ranging from 6 h at 750 °C to 7 min at 900 °C, oxide crystallites, exhibiting a tetragonal rutile TiO2 structure, were observed in Vs=0 samples to grow at an accelerated rate up through cracks in the oxide overlayer. The formation of these crystallites was postponed until a much later stage in oxide-overlayer development for samples grown with Vs=150 V.