TENSILE PROPERTIES OF SHORT FIBER-REINFORCED SIC/AL COMPOSITES .2. FINITE-ELEMENT ANALYSIS

The tensile properties of aluminum matrix composites containing SiC whiskers or particulate were investigated analytically and compared to experimental results. Two finite-element models were constructed and used for elastoplastic analysis. In both models, the SiC fibers are represented as longitudinally aligned cylinders in a three-dimensional array. The cylinder ends are transversely aligned in one model and staggered in the other. Using the models, the sensitivity of the predicted composite properties to the deformation characteristics of the matrix alloy was examined, and the general behavior of the models was validated. It was determined that both models are necessary to predict the overall composite stress-strain response accurately. The analytic results accurately predict: the observed composite stress-strain behavior; the experimentally observed increase in Young's modulus and the work-hardening rate with increasing fiber volume content and aspect ratio; and the decrease and subsequent increase in proportional limit as the SiC volume fraction is increased. The models also predict that the transverse material properties should be insensitive to fiber aspect ratio. In addition, the model predicts the location of initial yielding and the propagation of the plastic region. These results offer insights into the deformation mechanisms of short fiber-reinforced composites. © 1990 The Minerals, Metals & Materials Society - ASM International - The Materials Information Society.