MACHINE PARAMETER SELECTION FOR TURNING WITH CONSTRAINTS - AN ANALYTICAL APPROACH BASED ON GEOMETRIC-PROGRAMMING

被引：74

作者：

GOPALAKRISHNAN, B

ALKHAYYAL, F

机构：

[1] Department of Industrial Engineering, West Virginia University, Morgantown, WV, 26506

[2] Department of Industrial and Systems Engineering, Georgia Institute of Technology, Atlanta, GA

来源：

INTERNATIONAL JOURNAL OF PRODUCTION RESEARCH | 1991年 / 29卷 / 09期

关键词：

D O I：

10.1080/00207549108948056

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

This paper describes the design and development of an analytical tool for the selection of machine parameters in turning. The problem is to determine values for machine speed and feed that minimize the total cost of machining; specifically the costs associated with machining time and cutting tool wear. Geometric programming is used as the basic methodology, and the solution approach for the selection of machine parameters is based on an analysis of the complementary slackness conditions and realistic machining conditions. The quality of the solution is illustrated on several examples and compared to solutions obtained by some optimization methods proposed in the literature. In general, our technique is simple and straightforward and indicates how sensitive the solution is to the machine power consumed and surface finish attained.

引用

页码：1897 / 1908

页数：12

共 16 条

[1]

Armarego E., Brown R.H., The Machining of Metals, (1969)

[2]

Eightler C.S., Phillips B.T., Applied Geometric Programming, (1979)

[3]

Bhattacharya A., Faria Gonsalez R., Ham I., Regression analysis for predicting surface finish and its application in the determination of optimum machining conditions, Journal of Engineeringfor Industry, Transactions of the ASME, 93, pp. 711-714, (1970)

[4]

Brown R.H., On the selection of economical machining rates, International Journal of Production Research, 1, pp. 1-16, (1962)

[5]

Ermer D.S., Optimization of the constrained machining economics problem by geometric programming, Journal of Engineering for Industry, Transactions of the ASME, 93, pp. 1067-1072, (1971)

[6]

Ermer D.S., Kromordihardjo S., Optimization of multi-pass turning with constraints, Journal of Engineeringfor Industry, Transactions of the ASME, 103, pp. 462-468, (1981)

[7]

Gilbert W.W., Economics of machining, Machining-Theory and Practice, American Society of Metals, pp. 476-480, (1950)

[8]

Hitomi K., Analysis of production models-Part I: The optimal decision of production speeds, Aile Transactions, 8, pp. 96-105, (1976)

[9]

Okushima K., Hitomi K., Study of economical machining-analysis of maximum profit cutting speed, International Journal of Production Research, 3, pp. 73-78, (1964)

[10]

Petropoulos P.G., Optimal selection of machining rate variables by geometric programming, International Journal of Production Research, 11, pp. 305-314, (1973)

← 1 2 →