ORTHOGONAL MACHINING OF BONE

被引：60

作者：

WIGGINS, KL

MALKIN, S

机构：

[1] Department of Applied Mechanical Engineering, University of Petroleum and Minerals, Dhahran

[2] Faculty of Mechanical Engineering, Technion—Israel Institute of Technology, Haifa

来源：

JOURNAL OF BIOMECHANICAL ENGINEERING-TRANSACTIONS OF THE ASME | 1978年 / 100卷 / 03期

关键词：

D O I：

10.1115/1.3426202

中图分类号：

Q6 [生物物理学];

学科分类号：

071011 ;

摘要：

An investigation is described of the mechanics of orthogonal machining of bone. Experimental results are presented for the machining forces and specific energies for various cutting orientations, rake angles, and depths of cut. From microscopic observations on sections taken through the cutting zone, the chip formation process is seen to occur by a series of discrete fractures. A simple model is proposed to qualitatively describe the mechanics of chip formation. The energy expended by the cutting process under a wide variety of conditions is found to increase linearly with the surface area generated on the chip fragments, which is a further indication that chip formation during cutting of bone occurs by fracture. © 1978 by ASME.

引用

页码：122 / 130

页数：9

共 20 条

[1]

Meade R.H., An Introduction to the History of General Surgery, (1948)

[2]

Mettler C.C., History of Medicine, (1974)

[3]

Thorwald J., Sciences and Secrets of Early Medicine, pp. 300-308, (1962)

[4]

Smith S., Manual of the Principles and Practice of Operative Surgery, (1880)

[5]

Fergusson W., A System of Practical Surgery, (1848)

[6]

Warren J.C., Surgical Observations on Tiimors, (1837)

[7]

Thompson H.C., Effect of Drilling into Bone, Journal of Oral Surgery, 16, pp. 22-30, (1968)

[8]

Matthews L.S., Hirsch C., Temperatures Measured in Human Cortical Bone when Drilling, Journal of Bone Joint Surgery, 54A, pp. 297-308, (1972)

[9]

Hall R.M., The Effect of High-Speed Cutting with the Use of Water Coolant, Oral Surgery, Oral Medicine, and Oral Pathology, 20, (1965)

[10]

Jacobs C.H., Pope M.H., Berry J.T., Hoaglund F., A Study of the Bone Machining Process-Orthogonal Cutting, Journal of Biomechanics, 7, pp. 131-136, (1974)

← 1 2 →