Surface-directed, graft polymerization within microfluidic channels

We demonstrate a simple procedure to coat the surfaces of enclosed PDMS microchannels by UV-mediated graft polymerization. In prior applications, only disassembled channels could be coated by this method. This limited the utility of the method to coatings that could easily and tightly seal with themselves. By preadsorbing a photoinitiator onto the surface of PDMS microchannels, the rate of polymer formation at the surface was greatly accelerated compared to that in solution. Thus, a gel did not form in the lumen of enclosed microchannels. We demonstrate that the photoinitiator benzophenone remained on the surface of PDMS even after extensive washing. After addition of a variety of monomer solutions (acrylic acid, poly(ethylene glycol) monomethoxyl acrylate, or poly(ethylene glycol) diacrylate) and illumination with UV light, a stable, covalently attached surface coating formed in the microchannels. The electroosmotic mobility was stable in response to air exposure and to repeated cycles of hydration-dehydration of the coating. These surfaces also supported the electrophoretic separation of two model analytes. Placement of an opaque mask over a portion of the channel permitted photopatterning of the microchannels with a resolution of similar to100 mum. By using an appropriate mixture of monomers combined with masks, it should be possible to fabricate PDMS microfluidic devices with distinct surface properties in different regions or channels.