Overview of ITER physics deuterium-tritium experiments in JET

An overview of JET experimental results in DT plasmas directly relevant to ITER modes of operation is presented. Experiments in D:T mixtures varying from 100:0 to 10:90 and those carried out in hydrogen plasmas show that the H mode threshold power has an approximately inverse isotope mass dependence. Matching some of the key dimensionless parameters: to the ITER values, the ITER similarity experiments with ITER shape and safety factor q show that the global energy confinement time is practically independent of isotopic mass (similar to A(0.03+/-0.08)), where ii is the atomic mass of the hydrogenic species. Subtracting the edge pedestal energy (which scales as similar to A(0.57+/-0.2)) from the total stored energy leads to a similar to A(-0.17+/-0.1) dependence of confinement in the plasma core? very similar to that expected from the gyro-Bohm transport (similar to A(-0.2)) model. The observed scaling of the edge pedestal energy is consistent with a model in which the edge pressure gradient saturates at the ballooning limit over a region of width that scales as the ion poloidal Larmor radius governed by the average energy of the fast ions in the edge. The steady state total stored energy for a given input power in both ICRH and NBI discharges is the same despite the lower edge pedestal in the ICRH case, which is compensated for by more peaked power deposition profiles in ICRH. The ELM frequency is smaller with NBI; it decreases with isotopic mass in both NBI and ICRH discharges. A steady state, type I ELMy H mode discharge with ITER shape and q at 3.8 T/3.8 MA with an input power of 22 MW produced a Q approximate to 0.18 for 3.5 s and extrapolates well to ignition with ITER parameters. Here, Q is the ratio of fusion output power to input power. The thermal ELMy H mode confinement in both deuterium and tritium gas fuelled plasmas decreases significantly when the plasma density exceeds 0.75 of the Greenwald (n(GW)) limit, and the maximum density achieved is 0.85n(GW). In L mode, the density limit decreases with increasing isotope mass roughly in accordance with code predictions. ITER reference ICRH scenarios have been evaluated. Second harmonic heating of tritium at the densities available in JET produces strong tails and heats electrons predominantly as expected. The He-3 minority in 50:50 D:T and tritium dominated plasmas showed strong bulk ion heating leading to ion temperatures up to 13 keV with ICRH alone. Deuterium minority ion cyclotron heating in tritium plasmas at a pou er level of 0 MW produced steady state record values of Q approximate to 0.22 for more than 2.5 s.