Acid gel formation in (pseudo) alginates with and without G blocks produced by epimerising mannuronan with C5 epimerases

The main scope of this paper is the characterization, in terms of viscoelastic and mechanical properties, of acid gels formed from solutions of mannuronan ALG (0%G/0%GG) and its enzymatically epimerised products. The epimerised products were obtained using recombinantly produced mannuroman C5 epimerases named AlgE1 and AlgE4, which catalyse the conversion of mannuronic residues into guluronic (G) and guluronic-mannuronic (GM) blocks, respectively. The products used in this study resulted from either the action of AlgE I on mannuronan for 5 and 24 h (named ALG(44%G/32%GG) and ALG (68%G/59%GG), respectively) or AlgE4 on mannuronan (named ALG (47%G/0%GG)). D-gluconic acid-delta-lactone (GDL) was used as H+-donor to produce acidic gels. ALG (0%G/0%GG) yields strong, stable solid-like structures. As predicted by circular dichroism measurements performed at different pH, gelation of ALG (47%G/0%GG) occurs at lower values of pH (similar to 1) than those obtainable using GDL. Hydrochloric acid was therefore added to ALG (47%G/0%GG) solutions yielding rapid sol-gel transitions and gels with a remarkable resistance to thermal treatment. The introduction of guluronic residues along the chain (ALG (44%G/32%GG)) causes a reduction in the storage modulus at the equilibrium with respect to that of ALG (0%G/0%GG) and the occurrence of negligible syneresis at the highest polymer concentrations. The increase in the average length of the G blocks (ALG (68%G/59%GG)) is accompanied by a further increase in the storage modulus without the occurrence of my significant syneresis. (C) 2006 Elsevier Ltd. All rights reserved.