Cyclic deformation and near surface microstructures of shot peened or deep rolled austenitic stainless steel AISI 304

Cylindrical specimens of the austenitic stainless steel AISI 304 were shot peened or deep rolled with different peening intensities, and rolling pressures, respectively. The resulting near surface properties were characterized by cross sectioning transmission electron microscopy (TEM), residual stress and phase analysis as well as interference line half-width and microhardness measurements. Cyclic deformation curves were obtained by hysteresis measurements under stress control with zero mean stress. The microstructural alterations in the fatigued surface regions were again characterized by the above mentioned methods. The investigations revealed that both shot peening and deep rolling lead to a complex near surface microstructure, consisting of nanocrystalline regions, deformation bands and strain induced martensitic twin lamellae with high dislocation densities in the austenitic matrix. These microstructural changes severely influence the cyclic deformation behaviour: Plastic strain amplitudes and cyclic creep were drastically decreased by shot peening and especially by deep rolling. Both surface finishing methods were found to decrease crack initiation and propagation rate. Remarkably, the initial residual stress profile and surface strain hardening were not completely eliminated even by applying high cyclic stress amplitudes. This is due to the fact that during cyclic loading dislocation cell structures were only formed in greater depths whereas the nanocrystalline layer remained stable. In the case of deep rolled surfaces, the martensitic layer was even increased by fatigue-induced martensite formation. (C) 1999 Elsevier Science S.A. All rights reserved.