Microstructure and mechanical properties of 780 MPa high strength steels produced by direct-quenching and tempering process

Microstructure and mechanical properties of 780 MPa grade steel plate manufactured by conventional reheat-quenching and tempering (RQ-T) and direct-quenching and tempering (DQ-T) processes were investigated. The DQ process was found to enhance the hardenability of steel effectively so that tensile strengths of a range from 780 to 860 MPa have been achieved using DQ-T process, while tensile strength of about 770 MPa has been obtained from the RQ-T sample. In contrast, low temperature toughness of DQ-T samples was generally inferior to that of RQ-T sample, unless hot rolling and cooling processes were optimized in a controlled manner. For example, fracture appearance transition temperature (FATT) of DQ-T samples was varied in a range from -50degreesC to -120degreesC, while RQ-T specimens exhibited nearly constant FATT of about -80degreesC. The finish-rolling temperature (FRT) was one of potential process parameters to determine strength/toughness balance of the steel manufactured by DQ process, while the effect of FRT was closely associated with the cooling rate applied in the process. It has been demonstrated that, for the specimens quenched with a cooling rate higher than 20degreesC/sec, it may seem to be appropriate to adjust the FRT as low as possible in the non-recrystallization region. In contrast, for the specimens quenched with a low cooling rate of less than 10degreesC/sec, it may seem to be proper to apply higher FRT to obtain excellent strength/toughness balance of the steel. (C) 2002 Kluwer Academic Publishers.