On the dynamic electromechanical loading of dielectric elastomer membranes

被引:193
作者
Fox, J. W. [1 ]
Goulbourne, N. C. [1 ]
机构
[1] Virginia Polytech Inst & State Univ, Ctr Intelligent Mat Syst & Struct, Blacksburg, VA 24061 USA
关键词
membrane; dielectric sensors and actuators; dynamics; shells and membranes; rubber material;
D O I
10.1016/j.jmps.2008.03.007
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Dielectric elastomer actuators (DEAs) have received considerable attention recently due to large voltage-induced strains, which can be over 100%. Previously, a large deformation quasi-static model that describes the out-of-plane deformations of clamped diaphragms was derived. The numerical model results compare well with quasi-static experimental results for the same configuration. With relevance to dynamic applications, the time-varying response of initially planar dielectric elastomer membranes configured for out-of-plane deformations has not been reported until now. In this paper, an experimental investigation and analysis of the dynamic response of a dielectric elastomer membrane is reported. The experiments were conducted with prestretched DEAs fabricated from 0.5 mm thick polyacrylate films and carbon grease electrodes. The experiments covered the electromechanical spectrum by investigating membrane response due to (i) a time-varying voltage input and (ii) a time-varying pressure input, resulting in a combined electromechanical loading state in both cases. For the time-varying voltage experiments, the membrane had a prestretch of three and was passively inflated to various predetermined states, and then actuated. The pole strains incurred during the inflation were as high as 25.6%, corresponding to slightly less than a hemispherical state. On actuation, the membrane would inflate further, causing a maximum additional strain of 9.5%. For the time-varying pressure experiments, the prestretched membrane was inflated and deflated mechanically while a constant voltage was applied. The membrane was cycled between various predetermined inflation states, the largest of which was nearly hemispherical, which with an applied constant voltage of 3 kV corresponded to a maximum polar strain of 28%. The results from these experiments reveal that the response of the membrane is a departure from the classical dynamic response of continuum membrane structures. The dynamic response of the membrane is that of a damped system with specific deformation shapes reminiscent of the classical membrane mode shapes but without same-phase oscillation, that is to say all parts of the system do not pass through the equilibrium configuration at the same time. Of particular interest is the ability to excite these deformations through a varying electrical load at constant mechanical pressure. (C) 2008 Elsevier Ltd. All rights reserved.
引用
收藏
页码:2669 / 2686
页数:18
相关论文
共 43 条
[2]  
BAUER S, 2006, P SPIE SMART STRUCT
[3]  
BHATTACHARYA K, 2003, ELECTROACTIVE POLYM, P309
[4]   Dielectric elastomer cylindrical actuators: electromechanical modelling and experimental evaluation [J].
Carpi, F ;
De Rossi, D .
MATERIALS SCIENCE & ENGINEERING C-BIOMIMETIC AND SUPRAMOLECULAR SYSTEMS, 2004, 24 (04) :555-562
[5]   CLASSICAL NORMAL MODES IN DAMPED LINEAR DYNAMIC SYSTEMS [J].
CAUGHEY, TK ;
OKELLY, MEJ .
JOURNAL OF APPLIED MECHANICS, 1965, 32 (03) :583-&
[6]   FREE AND CONSTRAINED INFLATION OF ELASTIC MEMBRANES IN RELATION TO THERMOFORMING - NON-AXISYMMETRIC PROBLEMS [J].
CHARRIER, JM ;
SHRIVASTAVA, S ;
WU, R .
JOURNAL OF STRAIN ANALYSIS FOR ENGINEERING DESIGN, 1989, 24 (02) :55-74
[7]  
Choi HR, 2002, 2002 IEEE INTERNATIONAL CONFERENCE ON ROBOTICS AND AUTOMATION, VOLS I-IV, PROCEEDINGS, P3212, DOI 10.1109/ROBOT.2002.1013721
[8]  
Choi HR, 2002, 2002 IEEE INTERNATIONAL CONFERENCE ON ROBOTICS AND AUTOMATION, VOLS I-IV, PROCEEDINGS, P3218, DOI 10.1109/ROBOT.2002.1013722
[9]  
DERDOURI A, 1998, P ANTEC 98 ATL APR 2, V1, P672
[10]   Nonlinear electroelasticity [J].
Dorfmann, A ;
Ogden, RW .
ACTA MECHANICA, 2005, 174 (3-4) :167-183