Online Monitoring and Analysis of Resin Pressure Inside Composite Laminate During Zero-Bleeding Autoclave Process

Resin pressure is one of the most important parameters in manufacturing composites during autoclave process. It not only greatly influences resin flow behavior, but also has effects on void formation and elimination. Online monitoring resin pressure can provide an important guidance for the optimization of the processing parameters and the control of the quality of composites. In this study, a resin pressure online measuring system for autoclave process was established based on the principle of pressure transfer in liquid, and the size of the measuring probe of the system was optimized to increase the accuracy of measured resin pressure. The results indicate that the accuracy and the dynamic response of the system can meet the requirements of resin pressure measurement during autoclave process. Furthermore, by means of this proposed resin pressure measuring system and the measurements of compaction properties of the fabric stacks, the resin pressures inside carbon fiber fabric/epoxy resin and glass fiber fabric/epoxy resin prepreg stacks during autoclave process were investigated, especially for the zero-bleeding process which is prevailing for aircraft composite structures. It is demonstrated that during zero-bleeding process, the resin pressures, which conform to the spring and piston model, uniformly distribute along through-thickness and in-plane directions. In addition, the resin pressure profile is significantly influenced by the fiber volume fraction of the prepregs, indicating that fiber content of prepreg should be optimized for achieving free defects and uniform fiber distribution. POLYM. COMPOS., 32:314-323,2011. (C) 2010 Society of Plastics Engineers