Perforation of 12 mm thick steel plates by 20 mm diameter projectiles with flat, hemispherical and, conical noses Part II: numerical simulations

In Part I of this paper, projectiles with three different nose shapes (blunt, hemispherical and conical) were used in gas gun experiments to penetrate 12 mm thick Weldox 460 E steel plates. It was found that the nose shape of the projectile severely affected both the energy absorption and the failure mode of the target structure during penetration. This part of the paper describes numerical simulations of the problem investigated experimentally. A constitutive model of viscoplasticity and ductile damage for projectile impact has earlier been developed and implemented in the explicit finite element code LS-DYNA. Numerical simulations involving this model have been carried out, and the results are compared with the experimental data. However, numerical problems associated with the element mesh were detected, and adaptive meshing was found necessary in order to obtain reliable results for conical projectiles. From the numerical simulations it is found that the LS-DYNA code is able to describe the different failure modes without any predefined defects in the element mesh if special care is taken, and good agreement is in general obtained between the numerical simulations and experimental results. (C) 2001 Elsevier Science Ltd. All rights reserved.