Development of fast-dissolving tablets of flurbiprofen-cyclodextrin complexes

The present study was aimed at developing a tablet formulation based on an effective flurbiprofen-cyclodextrin system, able to allow a rapid and complete dissolution of this practically insoluble drug. Three different cyclodextrins were evaluated: the parent beta-cyclodextrin (previously found to be the best partner for the drug among the natural cyclodextrins) and two, amorphous, highly soluble beta-cyclodextrin derivatives, i.e., methyl-p-cyclodextrin and hydroxyethyl-beta-cyclodextrin. Equimolar drug-cyclodextrin binary systems prepared according to five different techniques (physical mixing, kneading, sealed-heating, coevaporation, and colyophilization) were characterized by Differential Scanning Calorimietry, x-ray powder diffractometry, infrared spectroscopy, and optical microscopy and evaluated for solubility and dissolution rate properties. The drug solubility improvement obtained by the different binary systems varied from a minimum of 2.5 times up to a maximum of 120 times, depending on both the cyclodextrin type and the system preparation method. Selected binary systems were used for preparation of direct compression tablets with reduced drug dosage (50 mg). Chitosan and spray-dried lactose, alone or in mixture, were used as excipients. All formulations containing drug-cyclodextrin systems gave a higher drug dissolved amount than the corresponding ones with drug alone (also at a dose of 100 mg); however, the drug dissolution behavior was strongly influenced by formulation factors. For example, for the same drug-cyclodextrin product the time to dissolve 50% drug varied from less than 5 minutes to more than 60 minutes' depending on the excipient used I-or tableting. In particular, only tablets containing the drug kneaded with methyl-beta-cyclodextrin or colyophilized with beta-cyclodextrin and spray-dried lactose as the only excipient satisfied the requirements of the Food and Drug Administration (FDA) for rapid dissolving tablets, allowing more than 85% drug to be dissolved within 30 minutes. Finally, it can be reasonably expected that the obtained drug dissolution rate improvement will result in an increase of its bioavallability, with the possibility of reducing drug dosage and side effects.