Microscopy of wear affected surface produced during sliding of Nimonic 80A against Stellite 6 at 20 °C

被引:27
作者
Du, HL [1 ]
Datta, PK
Inman, I
Geurts, R
Kübel, C
机构
[1] Northumbria Univ, Adv Mat Res Inst, Newcastle Upon Tyne NE2 8ST, Tyne & Wear, England
[2] FEI Co, Applicat Lab, Eindhoven, Netherlands
来源
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING | 2003年 / 357卷 / 1-2期
关键词
wear; glaze layer; oxidation; superalloy; TEM; nanostructure;
D O I
10.1016/S0921-5093(03)00258-2
中图分类号
TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
The microstructures of a wear induced surface glazed layer formed during sliding wear of Nimonic 80A against Stellite 6 at 20 degrees C using a speed of 0.314 ms(-1) under a load of 7 N have been investigated using X-ray diffraction analysis, scanning electron microscopy, and transmission electron microscopy in combination with electron energy loss spectroscopy (EELS) and energy dispersive X-ray (EDX) analysis. The results indicate the formation of a wear resistant nano-structured glazed layer. The mechanisms responsible for the formation of the nano-polycrystalline glazed layer are discussed. (C) 2003 Elsevier Science B.V. All rights reserved.
引用
收藏
页码:412 / 422
页数:11
相关论文
共 22 条
[1]   On the wear characteristics of cobalt-based hardfacing layer after thermal fatigue and oxidation [J].
Aoh, JN ;
Chen, JC .
WEAR, 2001, 250 (PART 1) :611-620
[2]  
BETTERIDGE W, 1974, NIMONIC ALLOYS
[3]  
DATTA S, 2001, I MAT TRIB M LOND NO
[4]  
DU HL, IN PRESS OXIDATION B
[5]   High resolution characterisation of tribochemical films on alumina [J].
Gee, MG ;
Jennett, NM .
WEAR, 1996, 193 (02) :133-145
[6]  
Ghosh AK, 2000, NATO SCI S PRT 3 HI, V80, P29
[7]   NANOCRYSTALLINE MATERIALS [J].
BIRRINGER, R .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1989, 117 :33-43
[8]   The effect of partial pressure of oxygen on the tribological behaviour of a nickel-based alloy, N80A, at elevated temperatures [J].
Jiang, JR ;
Stott, FH ;
Stack, MM .
WEAR, 1997, 203 :615-625
[9]  
JOHNSON M, 1990, DTI IND VALVE PROJEC, P61
[10]   Microstructural characterization of mechanically mixed layer and wear debris in sliding wear of an Al alloy and an Al based composite [J].
Li, XY ;
Tandon, KN .
WEAR, 2000, 245 (1-2) :148-161