Pitting corrosion of Al and Al-Cu alloys by ClO4- ions in neutral sulphate solutions

The influence of various concentrations of NaClO4, as a pitting corrosion agent, on the corrosion behaviour of pure Al, and two Al-Cu alloys, namely (Al + 2.5 wt% Cu) and (Al + 7 wt% Cu) alloys in 1.0 M Na2SO4 solution was investigated by potentiodynamic polarization and potentiostatic techniques at 25 degrees C. Measurements were conducted under the influence of various experimental conditions, complemented by ex situ energy dispersive X-ray (EDX) and scanning electron microscopy (SEM) examinations of the electrode surface. In free perchlorate sulphate solutions, for the three Al samples, the anodic polarization exhibits an active/passive transition. The active dissolution region involves an anodic peak (peak A) which is assigned to the formation of Al2O3 passive film on the electrode surface. The passive region extends up to 1500 mV with almost constant current density (j(pass)) without exhibiting a critical breakdown potential or showing any evidence of pitting attack. For the three Al samples, addition of ClO4- ions to the sulphate solution stimulates their active anodic dissolution and tends to induce pitting corrosion within the oxide passive region. Pitting corrosion was confirmed by SEM examination of the electrode surface. The pitting potential decreases with increasing ClO4- ion concentration indicating a decrease in pitting corrosion resistance. The susceptibility of the three Al samples towards pitting corrosion decreases in the order: Al > (Al + 2.5 wt% Cu) alloy > (Al + 7 wt% Cu) alloy. Potentiostatic measurements showed that the rate of pitting initiation increases with increasing ClO4- ion concentration and applied step anodic potential, while it decreases with increasing %Cu in the Al samples. The inhibitive effect of SO42- ions was also discussed. (C) 2008 Published by Elsevier Ltd.