Fabrication of highly transparent and superhydrophobic silica-based surface by TEOS/PPG hybrid with adjustment of the pH value

Preparation of superhydrophobic silica-based thin film with high transmittance (T%) in the visible light region by adjusting different pH value of mixing solution has been developed. The hybrid films were coated by the mixing solution which included precursor solution (sol-gel process) and polypropylene glycol (PPG) polymer solution. Rough surfaces were obtained by removing the organic polymer at high temperature and then the hydrophobic groups bonded onto the films were obtained by the reaction with hexamethyldisilazane (HMDS). Characteristic properties of the as-prepared surface of the films were analyzed by contact angle measurement, scanning electron microscopy (SEM), atom force microscopy (AFM), UV-VIS scanning spectrophotometer and Fourier transform infrared (FT-IR) spectrophotometer. The experimental parameters were mainly varied by the pH value (0, 1, 2.3, 6 and 8) of the mixing solution. The result showed that the contact angle of the film was greater than 150 degrees and the transmittance of the film was greater than 90% simultaneously when the pH value of mixing solution was adjusted to 1. In addition, the highly transparent superhydrophobic surfaces was obtained by adding 20 mu L acid solution into the mixing solution, which the contact angle of the film was 156.3 degrees as well as the transmittance of the film at the 600 nm visible light was 97.9%. (C) 2008 Elsevier B.V. All rights reserved.