共 50 条
Sulfonated multiblock copolynaphthalimides for polymer electrolyte fuel cell application
被引:35
作者:
Chen, Kangcheng
[1
]
Hu, Zhaoxia
[1
]
Endo, Nobutaka
[1
]
Higa, Mitsuru
[1
]
Okamoto, Ken-ichi
[1
]
机构:
[1] Yamaguchi Univ, Grad Sch Sci & Engn, Yamaguchi 7558611, Japan
来源:
关键词:
Sulfonated multiblock copolyimide;
Membrane anisotropy;
Polymer electrolyte fuel cell;
PROTON-EXCHANGE MEMBRANES;
POLY(ARYLENE ETHER SULFONE)S;
POLYIMIDE MEMBRANES;
WATER STABILITY;
ACID GROUPS;
CONDUCTIVITY;
COPOLYMERS;
PERFORMANCE;
DURABILITY;
LONOMERS;
D O I:
10.1016/j.polymer.2011.03.034
中图分类号:
O63 [高分子化学(高聚物)];
学科分类号:
070305 ;
080501 ;
081704 ;
摘要:
Sulfonated multiblock copolynaphthalimides (multiblock co-SPIs) were prepared by two-pot polymerization method from 1,4,5,8-naphthalenetetracarboxylic dianhydride, sulfonated diamine of 4,4'-bis(4-aminophenoxy)-3,3'-bis(4-sulfophenyl)biphenyl (BAPSPB) and nonsulfonated diamine of 4,4'-diaminophenyl hexafluoropropane. The multiblock co-SPI (BA1) with hydrophilic/hydrophobic block length of 20/10 and ion exchange capacity (IEC) of 1.67 meq g(-1) exhibited larger water uptake, larger in-plane and through-plane proton conductivity (sigma(parallel to) and sigma(perpendicular to) respectively) than the random co-SPI with the similar IEC. The multiblock co-SPI (BA2) with the longer block length of 20/20 exhibited the large sigma(parallel to) and sigma(perpendicular to) comparable to those of BA1, in spite of the smaller IEC of 135 meq g-1. Both the multiblock and random co-SPIs showed the moderate anisotropic proton conductivity (sigma(perpendicular to)/sigma(parallel to)(sic) 0.70) as well as anisotropic membrane swelling with about three times larger through-plane swelling than in-plane swelling. The TEM observation revealed that BA2 had an isotropic and inhomogeneous morphology with indistinct microphase-separated structure, whereas the random co-SPIs had a homogeneous morphology. The behavior of BAPSPB-based multiblock co-SPI membranes were quite different from that of the multiblock co-SPIs based on 2,2'-bis(4-sulfophenoxy) benzidine, which was due to the presence of two flexible ether bonds in BAPSPB moiety of the main chain. Even under the low humidification of 27/27% RH at 90 degrees C and 0.2 MPa, BA2 exhibited the fairly high PEFC performance; namely, cell voltage of 0.67 Vat load current density of 0.5 A cm(-2) and maximum output of 0.51 W cm(-2), which were much larger than those of BA1 and the random co-SPI (RA1) with IEC of 1.84 meq g(-1), and have the high potential as PEM for PEFC applications. (C) 2011 Elsevier Ltd. All rights reserved.
引用
收藏
页码:2255 / 2262
页数:8
相关论文