Variations in capture-zone geometry of a partially penetrating pumping well in an unconfined aquifer

Design of effective and efficient pump-and-treat systems requires capture zones of recovery wells to closely circumscribe the contaminant plume, Overestimation of capture zones incurs the undesired expense of treating clean water, Underestimation of capture zones enables contaminants to escape downgradient. Recovery wells in unconfined aquifers commonly penetrate only part of the aquifer either because of its large saturated thickness or the shallow vertical extent of contamination. The capture-zone geometry of a partially penetrating pumping well can differ greatly from that of a fully penetrating one because of vertical flow components near the well. The differences in geometry are far greater if the medium is anisotropic (K-h not equal K-v). To estimate the capture-zone geometry of a partially penetrating pumping well, a steady-state, finite-difference model was constructed to simulate flow to a well in a regional flow system, The model was used to simulate differences in the velocity field created by changes in (1) the depth of well penetration, (2) the magnitude of the regional hydraulic gradient, and (3) the degree of anisotropy. Following each simulation particle tracking was performed to determine the maximum width, depth, and distance to the stagnation point of the capture zone, Graphs were developed between capture-zone width, relative capture-zone depth, distance to the stagnation point, versus the ratio of Q/q (pumping rate/specific discharge), The graphs enable estimates to be made of these geometric parameters for a variety of pumping rates, regional hydraulic gradients, hydraulic conductivities, anisotropy ratios, and degrees of partial penetration. The results show that for isotropic conditions, particularly for small ratios of Q/q and wells that penetrate less than 40 percent of the aquifer, the shape of a capture zone can deviate significantly from that of a fully penetrating well. For anisotropic conditions, these differences are more pronounced and apply to a wider range of Q/q ratios and well penetration depths. In sequences of sediment, anisotropy is produced by textural, architectural, and stratigraphic elements that occur at different scales, Capture zones should be estimated using K-h:K-v ratios determined from pumping tests, This assures that the measured degree of anisotropy is commensurate with the scale of elements encountered by the stress created by a pumping well, Tabulated K-h:K-v ratios from analysis of pumping tests in unconfined aquifers suggest there are few isotropic sand and gravel aquifers, Recognition of this characteristic and consideration of the effects of partial penetration and regional hydraulic gradient ran the geometry of capture zones may lead to the design of more efficient and effective pump-and-treat systems.