Sintering stresses and distortion produced by density differences in bi-layer structures

被引:58
作者
Ravi, D [1 ]
Green, DJ [1 ]
机构
[1] Penn State Univ, Dept Mat Sci & Engn, University Pk, PA 16802 USA
关键词
sintering; porosity; mechanical properties; Al2O3; distortion;
D O I
10.1016/j.jeurceramsoc.2004.10.032
中图分类号
TQ174 [陶瓷工业]; TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
The variations in green density that arise when a powder is consolidated gives rise to strain rate incompatibility between regions that can result in densification stresses and or warpage during sintering. In order to quantity the effect of the green density variations, the shrinkage behavior of model bi-layers with a tailored density difference was analyzed. The methodology previously developed for co-firing of layered structures was applied to bi-layers for the case in which the layers do not differ in composition but in density. Alumina tapes with Green densities of 1.96 and 2.34 Mg/m(3) were fabricated by tape casting and consolidated into bi-layers. The shrinkage characteristics of the individual layers were characterized and the uniaxial viscosity of the layers with the two starting densities were determined as a function of the degree of densification using cyclic loading dilatometry. The distortion in the bi-layer configurations was experimentally measured and was shown to be in good agreement with the analytical calculations. (c) 2004 Elsevier Ltd. All rights reserved.
引用
收藏
页码:17 / 25
页数:9
相关论文
共 15 条
[1]   ON CONSTRAINED SINTERING .1. CONSTITUTIVE MODEL FOR A SINTERING BODY [J].
BORDIA, RK ;
SCHERER, GW .
ACTA METALLURGICA, 1988, 36 (09) :2393-2397
[2]  
BORDIA RK, 1988, ACTA METALL, V36, P2397
[3]  
Cai PZ, 1997, J AM CERAM SOC, V80, P1940, DOI 10.1111/j.1151-2916.1997.tb03076.x
[4]  
Cai PZ, 1997, J AM CERAM SOC, V80, P445, DOI 10.1111/j.1151-2916.1997.tb02850.x
[5]  
GARINO T, 1995, P 2N INT SAMPE TECHN
[6]   Viscosity of WC-Co compacts during sintering [J].
Gillia, O ;
Josserond, C ;
Bouvard, D .
ACTA MATERIALIA, 2001, 49 (08) :1413-1420
[7]  
GREEN DJ, 2002, 10 INT C MOD MAT TEC
[8]   STRESSES INDUCED BY DIFFERENTIAL SINTERING IN POWDER COMPACTS [J].
KELLETT, B ;
LANGE, FF .
JOURNAL OF THE AMERICAN CERAMIC SOCIETY, 1984, 67 (05) :369-371
[9]  
Lannutti JJ, 1997, AM CERAM SOC BULL, V76, P53
[10]   Bending creep test to measure the viscosity of porous materials during sintering [J].
Lee, SH ;
Messing, GL ;
Green, DJ .
JOURNAL OF THE AMERICAN CERAMIC SOCIETY, 2003, 86 (06) :877-882