Hydrometallurgical process for recovery of metal values from spent nickel metal hydride secondary batteries

A completely hydrometallurgical process has been developed for the recovery of metal values such as cobalt, nickel and rare earths from spent nickel-metal hydride (Ni-MH) secondary batteries. Effects of hydrochloric acid concentration, temperature, reaction time and solid-to-liquid ratio on leaching of metals contained in the electrode materials of the batteries were studied. The optimal operating conditions were found to be 3 M HCl at a temperature of 95 degrees C and a 3-h leach time, and it was possible to treat up to 5.5 g of scrap in 50 mi of acid solution where the recoveries 100% of cobalt, over 96% of nickel and 99% of rare earths were achieved. A typical chemical composition of the resulting leach liquor was approximately, in grams per liter, 23.4 Ni, 1.7 Co, 3.4 Fe, 0.72 Zn, 0.46 Al, 1.2 Mn, 4.2 La, 0.26 Ce, 0.82 Pr, 2.6 Nd and 0.074 Sm, as well as 50 Cl. The pH of the solution was around 1.2. The rare earth values can be readily recovered from the leach Liquor by the use of a solvent extraction circuit with 25% bis(2-ethylhexyl) phosphoric acid (D2EHPA) in kerosene, in which a two-stage counter-current extraction at an O:A ratio of 3:1 at an equilibrium pH of 2.0, a single-stage cobalt scrubbing with 0.3 M hydrochloric acid at an O:A ratio of 22:1, and a stripping operation with 2.0 M hydrochloric acid in one contact at an O:A ratio of 5:1 are involved. A mixed rare earth oxide of over 99% purity was obtained by selective precipitation with oxalic acid, and calcination of the precipitate. The total yield of rare earths approached 98%. The cobalt and nickel in the raffinate are effectively separated by selective extraction of cobalt with 25% TOA in kerosene after concentration (up to [Cl-] approximate to 220 g l(-1)). Nearly complete recovery of cobalt can be achieved by using a three-stage counter-current extraction at an O:A ratio of 2:1, followed by stripping with a dilute hydrochloric acid solution (pH 2.0) in a single stage at an O:A ratio of 4:1. Subsequently the cobalt in the strip liquor and the nickel remained in the raffinate are separately recovered as oxalates by the addition of ammonium oxalate. A pure cobalt product and a nickel oxalate with a purity close to 99.9% were obtained. The total recoveries of cobalt and nickel were found to be approx. 98% and 96%, respectively. (C) 1998 Published by Elsevier Science B.V. All rights reserved.