Application of a fiber-optic NIR-EFA sensor system for in situ monitoring of aromatic hydrocarbons in contaminated groundwater

Interaction of analyte molecules with the evanescent wave of light guided in optical fibers is among the most promising novel sensing schemes that can be applied for environmental monitoring and on-line process analysis. By combining this measuring principle with the solid-phase extraction of analyte molecules into the polymer cladding of a fiber, it is possible to perform direct absorption measurements in the cladding, if the fiber is adapted to a conventional spectrometer/photometer. A big advantage of this arrangement is that the measurement is scarcely disturbed by matrix effects (background absorption of water in IR measurements, stray light due to turbidity in the sample), By using near-infrared (NIR) evanescent field absorption (EFA) measurements in quartz glass fibers coated with a hydrophobic silicone membrane it is possible to design and construct sensors for monitoring apolar hydrocarbons (HCs) in aqueous matrices. The paper presents a fiber-optic sensor system for the determination of aromatic HCs in groundwater or industrial wastewater. Generally, this instrument is suitable for quantitative in situ monitoring of pollutants such as aromatic solvents, fuels, mineral oils or chlorinated HCs with relatively low water saturation solubility (typically between 0.01 and 10 gl(-1)). The sensor probe is connected via all-silica fibers to a filter photometer developed at the IFIA, thus, allowing even remote analysis in a monitoring well. This portable instrument provides a total concentration signal of the organic compounds extracted into the fiber cladding by measuring the integral absorption at the first C-H overtone bands in the NIR spectral range. In situ measurements with the sensor system were performed in a groundwater circulation well at the VEGAS research facility of the University of Stuttgart (Germany). The NIR-EFA sensor system was tested within the frame of an experiment that was carried through in a tank containing sandy gravel with a groundwater-saturated aquifer, where soil and groundwater were contaminated with technical grade xylene. The goal of this experiment was to model and optimize the groundwater circulation well used for the remediation of the aquifer and soil surrounding the well. The sensor proved to trace reliably the total hydrocarbon concentration in the process water pumped from the well to a stripper column. Measurements were performed continuously over 4 months with C8 HC sum concentrations in the process water between 80 mg l(-1) down to the limit of detection, which is around 200 mu gl(-1). It could be demonstrated that the fiber-optic sensor system is a valuable tool for near-real-time control of a remedial action technique and verification and documentation of its success. (C) 2001 Elsevier Science B.V. All rights reserved.