Crack propagation directions in unfilled resins

Posterior composite restorative materials undergo accelerated wear in the occlusal contact area, primarily through a fatigue mechanism. To facilitate the timely development of new and improved materials, a predictive wear model is desirable. The objective of this study was to develop a finite element model enabling investigators to predict crack propagation directions in resins used as the matrix material in composites, and to verify these predictions by observing cracks formed during the pin-on-disc wear of a 60:40 BISGMA:TEGDMA resin and an EBPADMA resin. Laser confocal scanning microscopy was used to measure crack locations. Finite element studies were done by means of ABAQUS software, modeling a cylinder sliding on a material with pre-existing surface-breaking cracks. Variables included modulus, cylinder/material friction coefficient, crack face friction, and yield behavior. Experimental results were surprising, since most crack directions were opposite previously published observations. The majority of surface cracks, though initially orthogonal to the surface, changed direction to run 20 to 30 degrees from the horizontal in the direction of indenter movement. Finite element modeling established the importance of subsurface sheer stresses, since calculations provided evidence that cracks propagate in the direction of maximum K-II(theta), in the same direction as the motion of the indenter, and at an angle of approximately 20 degrees. These findings provide the foundation for a predictive model of sliding wear in unfilled glassy resins.