Design, implementation and validation of a system for the dynamic reconfiguration of open architecture machine tool controls

被引：26

作者：

Oldknow, KD ^{[1
]}

Yellowley, I ^{[1
]}

机构：

[1] Univ British Columbia, Dept Mech Engn, Vancouver, BC V6T 1Z4, Canada

来源：

INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE | 2001年 / 41卷 / 06期

关键词：

D O I：

10.1016/S0890-6955(00)00109-7

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

This paper discusses the design and implementation of a system and protocol for the automatic configuration and dynamic reconfiguration of distributed machine tool control systems. A novel servo controller, based on a Field Programmable Gate Array (FPGA) hardware architecture is used to demonstrate the feasibility of the configuration system. (C) 2001 Elsevier Science Ltd. All rights reserved.

引用

页码：795 / 808

页数：14

共 26 条

[1]

Altintas Y, 1994, ANN CIRP, V43, P349

[2] The control of multiple constraints within an open architecture machine tool controller [J].

Ardekani, R ;

Yellowley, I .

JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME, 1996, 118 (03) :388-393

[3]

BAILO CP, 1991, P SOC PHOTO-OPT INS, V2912, P52

[4]

BRADLEY WM, 1994, 12751994 IEEE

[5]

CAFFREY R, 1997, AIAA IEEE DIG AV SYS, V1, P2

[6]

ECKERT B, 1999, FIRMWARE FACTORY USE

[7]

EROL NA, 1996, P SOC PHOTO-OPT INS, V2912, P13

[8]

*GM POW GMPTG, 1996, OP MOD ARCH CONTR GM

[9]

Koren Y., 1992, Annals of the CIRP, V41, P689

[10]

LUNDHOLM T, 1991, ANN CIRP, V40, P441

← 1 2 3 →