On-line monitoring of the photolysis of benzyl acetate and 3,5-dimethoxybenzyl acetate by membrane introduction mass spectrometry

Membrane introduction mass spectrometry (MIMS) allows on-line monitoring of the products of photolysis (254 nm) of benzyl acetate in aqueous methanol and 3,5-dimethoxybenzyl acetate in water. The reaction mixture is continuously exposed to a silicone membrane through which analyte molecules permeate into a triple quadrupole mass spectrometer for qualitative and quantitative analysis. Ionization is achieved by either isobutane or ammonia chemical ionization, and ions characteristic of the reactant ester and its products are monitored simultaneously and continuously. Three products, benzyl methyl ether, ethylbenzene, and bibenzyl are observed in the benzyl acetate photolysis. Two products, 3,5-dimethoxybenzyl alcohol and 3, 5-dimethoxyethylbenzene, are formed in the photolysis of 3,5-dimethoxybenzyl acetate. Quantitation is achieved through calibration using external standard solutions and, in the case of benzyl methyl ether, tandem mass spectrometry is used to verify product identification. During the photolysis of benzyl acetate, benzyl methyl ether and ethylbenzene are produced at onset with similar efficiencies. For the 3,5-dimethoxy ester photolysis, performed in aqueous solution, the efficiency of formation of the polar product 3,5-dimethoxybenzyl alcohol is about 300 times greater than that of the nonpolar product 3,5-dimethoxyethylbenzene. The results show that the relative reaction rates are dependent on the solvent and on the photon intensity and are consistent with earlier off-line experiments by Pincock et al. which showed that the photolysis proceeds through both ion and radical pair intermediates. To the best of our knowledge, the work reported here describes the first analysis of the photochemistry of an aralkyl ester in water and the first use of on-line mass spectrometry in a mechanistic study.