Surfactant-Triggered Fluorescence Turn "on/off" Behavior of a Polythiophene-graft-Polyampholyte

Polythiophene-graft-polyampholyte (PTP) is synthesized using N,N-dimethylaminoethyl methacrylate and tert-butyl methacrylate monomers by grafting from polythiophene backbone, followed by hydrolysis. The resulting polymer exhibits aqueous solubility via formation of small sized miceller aggregates with hydrophobic polythiophene at the center and radiating polyionic side chains (cationic or anionic depending on the pH of the medium) at the outer periphery. The critical micelle concentration of PTP in acidic solution (0.025 mg/mL, pH = 2.7) is determined from fluorescence spectroscopy. PTP exhibits reversible fluorescence on and off response in both acidic and basic medium with the sequential addition of differently charged ionic surfactants, repeatedly. The fluorescence intensity of PTP at pH 2.7 increases with the addition of an anionic surfactant, sodium dodecyl benzenesulfonate (SDBS), due to the self-aggregation forming compound micelles. The fluorescence intensity of these solutions again decreases on addition of a cationic surfactant, cetyltrimethylammonium bromide (CTAB), because of assembling of SDBS with CTAB, thus deassembling the PTP SDBS aggregates. At pH 9.2, these turn on and turn off responses are also shown by PTP with the sequential addition of cationic surfactant (CTAB) and anionic surfactant (SDBS), respectively. This result shows that PTP has potential for surfactant-induced reversible fluorescence turn on and off using ionic surfactant (SDBS and CTAB) through self-assembling and deassembling of the ionic aggregates. The reversible aggregation and disaggregation process of PTP with the surfactants at both acidic and basic pH is supported from dynamic light scattering and Fourier transform infrared spectroscopy. The morphology of the above systems studied by transmission and scanning electron microscopy also supports the above aggregation and disaggregation process.