Static and dynamic simulation of a 700-m high rock slope in western Norway

Static and dynamic rock slope stability analyses were performed using a numerical discontinuum modelling technique for a 700-m high rock slope in western Norway. The rock slope has been investigated by the Geological Survey of Norway (NGU), which has been carrying out rock slide studies for the county More and Romsdal in western Norway. The purpose of numerical modelling was to estimate the volume of the rock mass that could potentially slide under static and dynamic forces. This estimation was required to assess the run-up heights (tsunami) in a fjord that could potentially be caused by the rockslide. Three cases have been simulated for predicting the behaviour of the rock slope. First, an initial static loading is applied in the numerical model to simulate the prevailing rock mass conditions at the site. Second, saturated and weathered joint conditions are modelled by reducing the residual friction angle along the discontinuities of the rock mass. In doing so, the model simulates the effect of degradation of discontinuities in the rock slope. Third, a dynamic loading, based on peak ground accelerations expected in the area, is applied to simulate dynamic earthquake conditions. These numerical studies have provided some useful insights into the deformation mechanisms in the rock slope. Both sliding and rotation of blocks start to occur once the residual friction angle along the discontinuities is reduced and when the region is shaken by a strong earthquake. The results indicate that, due to variations in the inclination of discontinuities, the entire slope does not become unstable and that down-slope sliding and rotation of blocks occur mainly on the top layers of the slope. Within the range of parameter values considered for this study, it is unlikely that the whole rock slope can be destabilised. The study provides an illustration of how the geo-mechanical properties of a rock mass can be integrated in a discontinuum rock slope model, which is used for predicting the behaviour of the slope under existing environmental and earthquake conditions. This model has helped not only to better understand the dynamics of the rockslide but also to estimate the potential rock volume that can become unstable when subjected to static and dynamic loads. (C) 2003 Elsevier B.V. All rights reserved.