Characteristics of residual plastic zone under static and dynamic Vickers indentations

被引：56

作者：

Koeppel, BJ ^{[1
]}

Subhash, G ^{[1
]}

机构：

[1] Michigan Technol Univ, Dept Mech Engn Engn Mech, Houghton, MI 49931 USA

来源：

WEAR | 1999年 / 224卷 / 01期

基金：

美国国家科学基金会;

关键词：

residual plastic zone; Vickers indentations; strain rates; microstructural analysis;

D O I：

10.1016/S0043-1648(98)00328-7

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

An experimental technique based on elastic stress wave propagation phenomena in a slender rod is utilized for determining the dynamic Vickers indentation hardness in metals. Dynamic Vickers hardness (DVH) for several engineering metals is found to be greater than their static Vickers hardness (VH). The results were verified by obtaining the constitutive response of materials at similar strain rates and then correlating the yield stress with the corresponding hardness. The characteristics of the induced plastic zone under static and dynamic indentations were investigated by contouring microindentation hardness measurements and microstructural analysis of the deformed regions. The studies revealed that the size of the plastic zone is strongly a function of yield stress under static and dynamic conditions. (C) 1999 Published by Elsevier Science S.A. All rights reserved.

引用

页码：56 / 67

页数：12

共 33 条

[1]

[Anonymous], 1994, Dynamic Behavior of Materials, P66

[2]

[Anonymous], SCI HARDNESS TESTING

[3]

ASM International, 1992, ASM HDB, V4

[4]

ASM International, 1992, ASM HDB, V3

[5]

*ASTM, 1996, E38489 ASTM

[6]

*ASTM, 1996, E9282 ASTM

[7]

BATSON RG, 1918, P I MECH ENG, V2, P463

[8]

CLIFTON RJ, 1985, METALS HDB, V8, P230

[9] THE VARIATION OF HARDNESS AND WEAR COEFFICIENT IN SLIDING WEAR OF COPPER AND ALUMINUM-ALLOYS [J].

ELTAYEB, N .

WEAR, 1994, 174 (1-2) :63-69

[10]

FEE AR, 1985, METALS HDB, P71

← 1 2 3 4 →