Optimising the design of fume extraction hoods using a combination of engineering and CFD modelling

Fume and hygiene hoods are widely used to prevent fugitive emissions from charge ports, tap holes and many other openings in mineral processing and smelting vessels. The highly buoyant nature of the fume combined with often complex geometries make the design of these hoods difficult with traditional engineering tools. However, by combining the traditional engineering approach with computational fluid dynamics (CFD) techniques, a clear understanding of the shortfalls of an existing system can be obtained, and an optimised hood design can be achieved. This paper reports on a combined engineering and CFD analysis of a fume extraction system for a zinc slag fumer charge port. The engineering model revealed that the existing plant components (bag house and fan) were not capable of capturing the required amount of fume, and that the original hood design was flawed. The CFD model was then used to predict the fume capture and emission from the existing hood. CFD model predictions showed that increasing the draft flow rate by an order of magnitude would only give a marginal improvement in fume capture. Using findings of both the models enabled a new fume capture hood to be designed. CFD analysis of the new hood revealed that a significant improvement in fume capture is possible. Construction and installation of the hood has been performed and a 65% reduction in fume emission was achieved, thus significantly mitigating a long-standing emission problem. Crown Copyright (c) 2006 Published by Elsevier Inc. All rights reserved.