The effects of tibial component inclination on bone stress after unicompartmental knee arthroplasty

Unlike the case with total knee arthroplasty. the femorotibial angle (FTA) after unicompartmental knee arthroplasty (UKA) does not directly depend on the inclination of the tibial component when the height of the joint line is maintained. This study analyzed the effects of the inclination of the tibial component in the coronal plane on the contact pressure of the implant-bone surface and the stresses on the proximal tibia. A two-dimensional, coronal plane model of the proximal tibia was subjected to finite-element analysis. Sixteen patterns of finite-element models of equal FTA were developed in which the inclination of tibial components ranged from 5degrees valgus to 10degrees varus in increments of 1degrees. Stress concentration at the proximal medial diaphyseal cortex gradually increased as the inclination changed from valgus to varus. Maximum contact pressure on the metal-bone interface similarly changed and shifted from the lateral edge to the medial edge of the implant as the inclination changed to varus. It was found that even without changing FTA. the inclination of the tibial component might affect stress concentration and contact pressure in the proximal tibia after UKA, The results suggested that slight valgus inclination of the tibial component might be preferable to varus and even to 0degrees (square) inclination so far as the stress distribution is concerned. (C) 2002 Elsevier Science Ltd. All rights reserved.