Numerical simulation of the effects of volume fraction, aspect ratio and fibre length distribution on the elastic and thermoelastic properties of short fibre composites

In this paper a new numerical procedure by Gusev, for predicting the elastic and thermoelastic properties of short fibre reinforced composites, is described. Computer models, comprising 100 non-overlapping aligned spherocylinders, were generated using a Monte Carlo procedure to produce a random morphology. Periodic boundary conditions were used for all the generated structures. Where necessary, the generated microstructures were based on measurements of real materials: for example a measured fibre length distribution was used to seed the Monte Carlo generator to produce a computer model with an equivalent fibre length distribution (FLD). The generated morphologies were meshed using an intelligent 3 dimensional meshing technique, allowing the elastic and thermo-elastic properties of the microstructures to be calculated. The numerical predictions were compared with those from three commonly used micromechanical models, namely those attributed to Halpin/Tsai, Tandon/Weng and Cox (shear lag). Firstly, the effect of volume fraction and aspect ratio were investigated, and the numerical results were compared and contrasted with those of the chosen models. Secondly, the numerical approach was used to investigate what effect a distribution of fibre lengths, as seen in real materials, would have on the predicted mechanical properties. The results were compared with simulations carried out using a monodispersed fibre length, to ascertain if the distribution of lengths could be replaced with a single length, and whether this length corresponded to a particular characteristic of the distribution, for example the first moment or average length. (C) 2002 Elsevier Science Ltd. All rights reserved.