HNO3/H3PO4-NANO2 mediated oxidation of cellulose -: preparation and characterization of bioabsorbable oxidized celluloses in high yields and with different levels of oxidation

The reaction of cellulose with a mixture of HNO3/H3PO4-NaNO2 (2:1:1.4, v/v/%w) at room temperature for different time intervals has been investigated to produce oxidized cellulose (OC), a biocompatible and bioresorbable polymer. The results revealed an increase in carboxyl content of OC with increasing reaction time, corresponding to about 8.0, 13.4, 17.4 and 18.4% carboxyl content after 12, 24, 36, and 48 h, respectively. The yield of OC ranged between 75 and 81%. The use of different ratios of HNO3 and H3PO4, (11:1, 4:1, 2:1, 1:1, 1:2, and 1:4; v/v), in the reaction had no significant effect on the carboxyl content and yield of the OC products. All products, as produced, were low crystallinity (27-35%) fibrous materials. The length of fibers decreased with increasing reaction time. After ball milling for 24 h, the length of fibers further decreased and products converted into a fine powder consisting of small fibers and aggregated non-fibrous particles. The degrees of polymerization (DP) of the OC products produced after 12, 24, and 48 h of reaction duration were 81, 63, and 53, respectively. After ball milling for 24 h, the corresponding values changed to 57, 51 and 46. However, no significant change in the crystallinity of the products was noted after ball milling. The TGA results showed the OC products to be less thermally stable than cellulose. The degradation temperature appears to decrease with increasing carboxyl content. In conclusion, the results show that the low crystallinity OC products can be successfully prepared in high yields and with different levels of carboxyl content from cellulose by treatment with a mixture of HNO3/H3PO4-NaNO2. (C) 2002 Elsevier Science Ltd. All rights reserved.