Spectrophotometric determination of uranium In process streams of a uranium extraction plant

This paper deals with the development and standardization of procedures for the determination of uranium on a routine basis in various process streams of a uranium extraction plant, covering a wide range of concentrations from 350 g 1(-1) down to 5 mg 1(-1) using only a. spectrophotometric technique. The self-absorption of uranyl ion in dilute phosphoric acid and the violet-blue colour of the UO22+ -Arsenazo III complex in 4 M HCl were exploited for high and low concentrations of uranium, respectively. The methods described were applied to samples of varying nature such as aqueous, organics and solids, involve minimal sample preparation and do not require prior separation of uranium from impurities. The interfering impurities in different process streams were also studied. Large quantities of silica as undissolved material poses a serious interference in the case of UNS and UNF. Considerable quantities of iron in UNS, UNF, UNR and UNRC cause interference. Possible remedies in these cases are suggested. Problems with the direct spectrophotometric measurement of organic samples is discussed. The effect of the presence of large quantities of ammonium nitrate and sodium nitrate in WD samples on the determination of uranium is also discussed. concentrations of uranium and by extraction-spectrophotometry (ethyl acetate-thiocyanate method) for lower concentrations. Relative standard deviation of 1% and 5% for high and low concentrations, respectively, were obtained, which are adequate as far as process stream samples are concerned. The compared results are in fair agreement. The problems associated with the determination of uranium in these process streams are discussed. Experimental results for 10 different process streams normally encountered in a uranium extraction plant are tabulated.