Performance analysis of organic Rankine cycle based on location of heat transfer pinch point in evaporator

被引：75

作者：

Guo, Cong ^{[1
]}

Du, Xiaoze ^{[1
]}

Yang, Lijun ^{[1
]}

Yang, Yongping ^{[1
]}

机构：

[1] North China Elect Power Univ, Key Lab Condit Monitoring & Control Power Plant E, Minist Educ, Beijing 102206, Peoples R China

来源：

APPLIED THERMAL ENGINEERING | 2014年 / 62卷 / 01期

基金：

中国国家自然科学基金;

关键词：

Organic Rankine cycle; Heat transfer pinch point; Low and medium grade heat utilization; Thermal efficiency; Heat transfer area; WORKING FLUIDS; TEMPERATURE; EXCHANGER; MIXTURES; PRESSURE;

D O I：

10.1016/j.applthermaleng.2013.09.036

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

The location of heat transfer pinch point in evaporator is the base of determining operating parameters of organic Rankine cycle (ORC). The physical mathematical model seeking the location of pinch point is established, by which, the temperature variations both of heat source and working fluid with UA can be obtained. Taking heat source with inlet temperature of 160 degrees C as example, the matching potentials between heat source and working fluid are revealed for subcritical and supercritical cycles with the determined temperature difference of pinch point. Thermal efficiency, exergy efficiency, work output per unit area and maximum work outputs are compared and analyzed based on the locations of heat transfer pinch point either. The results indicate that supercritical ORC has a better performance in thermal efficiency, exergy efficiency and work output while outlet temperature of heat source is low. Otherwise, subcritical performs better. Small heat transfer coefficient results in low value of work output per unit area for supercritical ORC. Introduction of IHX may reduce the optimal evaporating pressure, which has a great influence on heat source outlet temperature and superheat degree. The analysis may benefit the selection of operating parameters and control strategy of ORC. (c) 2013 Elsevier Ltd. All rights reserved.

引用

页码：176 / 186

页数：11

共 33 条

[1]

Angelino G., 2000, FUEL CELL SEM PORTL, P667

[2] Bottoming cycles for electric energy generation: Parametric investigation of available and innovative solutions for the exploitation of low and medium temperature heat sources [J].