Gas-water-rock interactions in Frio Formation following CO2 injection:: Implications for the storage of greenhouse gases in sedimentary basins

To investigate the potential for the geologic storage of CO2 in saline sedimentary aquifers, 1600 t Of CO2 were injected at 1500 m depth into a 24-in-thick sandstone section of the Frio Formation, a regional brine and oil reservoir in the U.S. Gulf Coast. Fluid samples obtained from the injection and observation wells before CO2 injection showed a Na-CaCl-type brine with 93,000 mg/L total dissolved solids (TDS) at near saturation with CH4 at reservoir conditions. Following CO2 breakthrough, samples showed sharp drops in pH (6.5-5.7), pronounced increases in alkalinity (100-3000 mg/L as HCO3) and Fe (30-1100 mg/L), and significant shifts in the isotopic compositions of H2O, dissolved inorganic carbon (DIC), and CH4. Geochemical modeling indicates that brine pH would have dropped lower but for the buffering by dissolution of carbonate and iron oxyhydroxides. This rapid dissolution of carbonate and other minerals could ultimately create pathways in the rock seals or well cements for CO2 and brine leakage. Dissolution of minerals, especially iron oxyhydroxides, could mobilize toxic trace metals and, where residual oil or suitable organics are present, the injected CO2 could also mobilize toxic organic compounds. Environmental impacts could be major if large brine volumes with mobilized toxic metals and organics migrated into potable groundwater. The 8180 values for brine and CO2 samples indicate that supercritical CO2 comprises similar to 50% of pore-fluid volume similar to 6 mo after the end of injection. Postinjection sampling, coupled with geochemical modeling, indicates that the brine gradually will return to its preinjection composition.