Development of the dry sand rubber wheel abrasion test

被引：74

作者：

Stevenson, ANJ ^{[1
]}

Hutchings, IM ^{[1
]}

机构：

[1] UNIV CAMBRIDGE,DEPT MAT SCI & MET,CAMBRIDGE CB2 3QZ,ENGLAND

来源：

WEAR | 1996年 / 195卷 / 1-2期

基金：

英国工程与自然科学研究理事会;

关键词：

abrasion test; friction force; load; sliding speed; rubber hardness;

D O I：

10.1016/0043-1648(96)06965-7

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

A rubber wheel abrasion tester with some advantages over the design described in ASTM G65 has been designed and characterised. In the new design the specimen was held horizontally. It was therefore possible to determine the actual mass flow rate of abrasive abrading the specimen and consequently the number of particles in the contact zone and the load carried by each particle. The abrasive feed system was designed to improve control over the conditions in the contact region. The performance of the apparatus was evaluated in tests on low carbon (AISI 1020) steel, with wheels made from cast polyurethane and chlorobutyl rubber. The influences of load, sliding speed and rubber hardness were investigated. Temperature rises of wheel, specimen and sand, and the friction force were measured; the main mechanism of heat dissipation was through the continual flow of fresh abrasive past the specimen.

引用

页码：232 / 240

页数：9