Deformation of single crystal Hadfield steel by twinning and slip

The stress-strain behavior of Hadfield steel (Fe, 12.34 Mn, 1.03 C, in wt%) single crystals was studied for selected crystallographic orientations ([111], [001] and [123]) under tension and compression. The overall stress-strain response was strongly dependent on the crystallographic orientation and applied stress direction. Transmission electron microscopy and in situ optical microscopy demonstrated that twinning is the dominant deformation mechanism in [111] crystals subjected to tension, and [001] crystals subjected to compression at the onset of inelastic deformation. In the orientations that experience twinning, the activation of multiple twinning systems produces a higher strain-hardening coefficient than observed in typical f.c.c. alloys. Based on these experimental observations, a model is presented that predicts the orientation and stress direction effects on the critical stress for initiating twinning. The model incorporates the role of local pile-up stresses, stacking fault energy, the influence of the applied stress on the separation of partial dislocations, and the increase in the friction stress due to a high solute concentration. On the other hand, multiple slip was determined to be the dominant deformation mechanism in [111] crystals subjected to compression, and [001] crystals deformed under tension. Furthermore, the [123] crystals experience single slip in both tension and compression with planar type dislocations. Using electron back-scattered diffraction patterns, macroscopic shear bands (MSBs) were identified with a misorientation of 9 degrees in the compressed [111] single crystals at strains as low as 1%. (C) 2000 Acta Metallurgica Inc. Published by Elsevier Science Ltd. All rights reserved.