Improvement of salt-affected soils, part 2: Interception of capillarity by soil sintering

被引:12
作者
Jia, H.
Zhang, H.
Araya, K. [1 ]
Guo, G.
Zhang, Z.
Ohomiya, K.
Matsuda, J.
机构
[1] Hejiang Agr Res Inst, Jiamusi, Black Dragon, Peoples R China
[2] Senshu Univ, Environm Sci Lab, Bibai, Hokkaido 0790197, Japan
[3] Hokkaido Univ, Sapporo, Hokkaido 0600009, Japan
[4] Agr Expt Stn Inner Mongolia, Huhehaoto 010010, Inner Mongolia, Peoples R China
关键词
D O I
10.1016/j.biosystemseng.2006.01.013
中图分类号
S2 [农业工程];
学科分类号
0828 ;
摘要
In this paper, a new method is discussed for the soil improvement of salt-affected soils in regions where a sufficient amount of rainfall occurs in summer. The sub-soil is made coarse by soil sintering, and the capillarity from groundwater is cut off. Thus, the rise to the soil surface of salts which are dissolved in the groundwater can be prevented, and even if the groundwater level is high, the evaporation of water from the soil surface can be reduced. Moreover, the salts that accumulate in the topsoil can be washed out by rainfall (leaching) during the summer season. Consequently, this method has the same effect as when the groundwater level is lowered. This paper deals with the determination of the degree of aggregation of the soil particles and the height of water raised by capillarity due to different soil sintering temperatures. The results show that the behaviour caused by sintering was similar for all soils. Sintering creates more and more coarse conditions and black colour. Non-sintered soils were saturated with distilled water and became permanently dispersed. In the soils sintered at more than 800 degrees C, there was no disaggregation of the soil particles in the water, so it is considered that the sintering temperature should be greater than 800 degrees C. In the non-sintered soils, the mean diameter of the soil particles was small (0.005-0.013 mm). If these soils were sintered, the soil aggregate size increased sharply. Even at the lowest sintering temperature (600 degrees C), the mean diameter of the soil aggregate increased to about 4 mm. When the sintering temperature was 1300 degrees C, the mean diameter of the soil aggregate rose to about 8 mm. The capillary water heights of the non-sintered salt-affected soils were predicted at some metres. With sintering, this water height was less than 0.15 m, even when the sintering temperature was the lowest (600 degrees C). If the soils were sintered with temperatures higher than 1000 degrees C, the water height by capillarity was less than 0.09 m. Thus, if about 100 mm thickness of the sub-soil just below the B horizon can be sintered, the capillarity from the groundwater can be intercepted, thus reducing water loss through evaporation and increasing salt removal through leaching during the rainy season. (c) 2006 IAgrE. All rights reserved. Published by Elsevier Ltd.
引用
收藏
页码:263 / 273
页数:11
相关论文
共 14 条
[1]  
ABROL IP, 1988, SALT AFFECTED SOILS, P5
[2]   Construction of an artificial perched watertable, part 1: Air permeability of soils and aspects of soil failure [J].
Araya, K ;
Guo, G .
BIOSYSTEMS ENGINEERING, 2002, 81 (03) :333-345
[3]  
CARDON GE, 2001, 9503 COL STAT U, P1
[4]  
DUDAL R, 1969, LEGEND FAO UNESCO SO
[5]  
FUJIMOTO T, 1963, HYDRODYNAMICS, P36
[6]   Construction of an artificial perched watertable, Part 3: Sand gun [J].
Guo, G ;
Araya, K .
BIOSYSTEMS ENGINEERING, 2003, 85 (03) :307-317
[7]  
GUO G, 2006, BIOSYSTEMS ENG, DOI DOI 10.1016/J.BIOSYSTEMSENG.2006.01.008
[8]  
HASHIMOTO K, 1975, CERAMICS, P17
[9]  
HORI T, 1957, PHYSICS, P130
[10]  
SCHEFFER F, 1976, LEHRBUCH BODENKUNDE, P407