The effect of composition and of surface properties on alcoholcoupling reactions was studied on MgyAlOx catalysts using C2H5OH or (CH3OH)-C-13/1-(C3H7OH)-C-12 mixtures as reactants. Samples with Mg/Al ratios of 0.5-9.0 were obtained by thermal decomposition of precipitated hydrotalcite precursors. The nature, density, and strength of surface basic sites were obtained by temperature-programmed desorption (TPD) of CO2 and by (CO2)-C-13/(CO)-C-12 isotopic switch methods, whereas the acid site densities were measured by TPD of NH3. The catalyst ability for activating H-H bonds was investigated by performing H-2-D-2 steady-state equilibration reactions. Isotopic tracer studies were carried out in order to probe chain growth pathways in the synthesis of isobutanol. The rates and product selectivity for C2H5OH or CH3OH/C3H7OH reactions strongly depended on the chemical composition of MgyAlOx samples. In turn, the chemical composition affected the acid-base properties of MgyAlOx samples by modifying surface acid and base site densities and the distribution of strength for such sites. The rate of alcohol dehydration to ethers and olefins increased with increasing Al content. Al-rich MgyAlOx samples contained a high density of Al3+-O2- site pairs and of moderate strength basic sites, the combination of which promoted the formation of ethylene or propylene from primary alcohols via E-2 elimination pathways. The competitive dehydration to form ethers involved the adsorption of two alcohol molecules on neighboring active sites offering different acid-base properties. On MgyAlOx samples, the active acid sites for ether formation were probably the Al3+ cations, whereas the basic sites were the neighboring O2- ions. The abundance of surface Al3+-O2- pairs accounted for the high ether formation rates observed on Al2O3 and Al-rich MgyAlOx samples. The dehydrogenation of alcohols to aldehydes (C2H4O or C3H6O) involved the initial alkoxy intermediate formation on weak Lewis acid-strong Bronsted base site pairs. The synthesis of C2H4O or C3H6O was favored on Mg-rich MgyAlOx samples because these samples contained a much larger number of properly positioned Al3+ Lewis acid sites and Mg2+-O2- basic pairs, which are required for hydrogen abstraction steps leading to alkoxy intermediates. Pure MgO showed lower dehydrogenation rates than Mg-rich MgyAlOx samples because the predominant presence of isolated O2- hindered formation of alkoxy intermediates by alcohol dissociative adsorption. Aldol condensation reactions on MgyAlOx samples involved also the formation of a carbanion intermediate on Lewis acid-strong Bronsted base pair sites and yielded products containing a new C-C bond such as n-C4H8O (or n-C4H9OH) and iso-C4H8O (or iso-C4H9OH). Reactions leading to condensation products were also favored on Mg-rich samples, but they took place at much slower rates than those of the corresponding dehydrogenation reactions to aldehydes. This reflected the bimolecular and consecutive character of condensation reactions, which are affected not only by the catalyst acid-base properties but also by the chemical nature of the alcohols and steric factors. (C) 2000 Academic Press.
