Electroreduction of graphite in LiClO4-ethylene carbonate electrolyte. Characterization of the passivating layer by transmission electron microscopy and Fourier-transform infrared spectroscopy

Electrochemical intercalation of unsolvated lithium into pitch carbon fibres P100 and natural graphite UF4 has been carried out in LiClO4-ethylene carbonate electrolyte. The reversible electrochemical capacity for a current equal to 7 mu A/mg is 260 mAh/g for P100 carbon fibres and about 350 mAh/g for UF4 graphite, respectively. During the first discharge (reduction) an electrochemical capacity greater than the theoretical value (372 mAh/g) corresponding to LiC6 is obtained. This excess of capacity can be related to the formation of a passivating layer on the carbon surface. Analysis of this layer by means of transmission electron microscopy (electron diffraction, electron energy loss spectroscopy, and imaging) and Fourier-transform infrared spectroscopy has shown that this layer is composed of lithium carbonate Li2CO3 and alkylcarbonates of lithium ROCO(2)Li. Formation of Li2CO3 occurs at potentials in the 1-0.8 V range versus Li+/Li, and formation of lithium alkylcarbonates then follows at potentials below 0.8 V. We then attributed the voltage plateau at 0.9 V versus Li+/Li observed in the electrochemical waves to the reduction of ethylene carbonate into Li2CO3. Transmission electron spectroscopy revealed the presence of lithium chloride in the electrolyte which appears as small rods.