Development and application of a three-dimensional aerosol chemical transport model, PMCAMx

A three-dimensional chemical transport model (PMCAMx) is used to simulate PM mass and composition in the eastern United States for a July 2001 pollution episode. The performance of the model in this region is evaluated, taking advantage of the highly time and size-resolved PM and gas-phase data collected during the Pittsburgh Air Quality Study (PAQS). PMCAMx uses the framework of CAMx and detailed aerosol modules to simulate inorganic aerosol growth, aqueous-phase chemistry, secondary organic aerosol formation, nucleation, and coagulation. The model predictions are compared to hourly measurements of PM2.5 mass and composition at Pittsburgh, as well as to measurements from the AIRS and IMPROVE networks. The performance of the model for the major PM2.5 components (sulfate, ammonium, and organic carbon) is encouraging (fractional errors are in general smaller than 50%). Additional improvements are possible if the rainfall measurements are used instead of the meteorological model predictions. The modest errors in ammonium predictions and the lack of bias for the total (gas and particulate) ammonium suggest that the improved ammonia inventory used is reasonable. The significant errors in aerosol nitrate predictions are mainly due to difficulties in simulating the nighttime formation of nitric acid. The concentrations of elemental carbon (EC) in the urban areas are significantly overpredicted. This is a problem related to both the emission inventory but also the different EC measurement methods that have been used in the two measurement networks (AIRS and IMPROVE) and the actual development of the inventory. While the ability of the model to reproduce OC levels is encouraging, additional work is necessary to confirm that that this is due to the right reasons and not offsetting errors in the primary emissions and the secondary formation. The model performance against the semi-continuous measurements in Pittsburgh appears to be quite similar to its performance against daily average measurements in a wide range of stations across the Eastern US. This suggests that the skill of the model to reproduce the diurnal variability Of PM2.5 and its major components is as good as its ability to reproduce the daily average values and also the significant value of high temporal resolution measurements for model evaluation. (c) 2006 Elsevier Ltd. All rights reserved.