Annealing effects of tribolurninescence production on irradiated ZnS:Mn

被引:8
作者
Hollerman, W. A.
Bergeron, N. P.
Goedeke, S. M.
Allison, S. W.
Muntele, C. I.
Ila, D.
Moore, R. J.
机构
[1] Univ SW Louisiana, Dept Phys, Lafayette, LA 70504 USA
[2] Oak Ridge Natl Lab, Engn Sci & Technol Div, Oak Ridge, TN 37831 USA
[3] Alabama A&M Univ, Ctr Irradiat Mat, Normal, AL 35762 USA
关键词
triboluminescence; ZnS : Mn; ion irradiation;
D O I
10.1016/j.surfcoat.2006.10.054
中图分类号
TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
The current interest in returning to the Moon and Mars by 2030 makes cost effective and low mass health monitoring sensors essential for spacecraft development. In space, there are many surface measurements that are required to monitor the condition of the spacecraft including: surface temperature, radiation fluence, and impact. Through the use of phosphors, materials doped with trace elements that give off visible light when excited, these conditions can be monitored. Practical space-based phosphor sensors will depend heavily upon research investigating the resistance of phosphors to ionizing radiation and the ability to anneal or self-heal from damage caused by ionizing radiation. Preliminary investigations into these sensors have recently been performed using a highly triboluminescent phosphor, ZnS:Mn. This phosphor has been found to be temperature sensitive from 100 to 350 degrees C and responsive to both impact and radiation fluence. A 3 MeV proton fluence as small as 2.3 x 10(13) MM-2 was found to statistically reduce the ZnS:Mn fluorescence decay time for temperatures less than 200 degrees C. Reductions in decay time appear to be proportional to increasing fluence. These results have stimulated research into the effects of thermal annealing on triboluminescence. While this testing is not all-inclusive; it does illuminate the process that can be used in the selection of appropriate sensor materials. (C) 2007 Elsevier B.V. All rights reserved.
引用
收藏
页码:8382 / 8387
页数:6
相关论文
共 12 条
[1]  
Bergeron NP, 2005, AIP CONF PROC, V746, P762
[2]   MECHANICAL CHARACTERISTICS AND MECHANISM OF THE TRIBOLUMINESCENCE OF FLUORESCENT MOLECULAR-CRYSTALS [J].
CHANDRA, BP ;
ZINK, JI .
JOURNAL OF CHEMICAL PHYSICS, 1980, 73 (12) :5933-5941
[3]   Effects of proton irradiation on triboluminescent materials such as ZnS:Mn [J].
Hollerman, WA ;
Goedeke, SM ;
Bergeron, NP ;
Muntele, CI ;
Allison, SW ;
Ila, D .
NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION B-BEAM INTERACTIONS WITH MATERIALS AND ATOMS, 2005, 241 (1-4) :578-582
[4]  
HOLLERMAN WA, 2005, SOC PHOTO OPTICAL IN, V10, P5897
[5]   Triboluminescent materials for structural damage monitoring [J].
Sage, I ;
Bourhill, G .
JOURNAL OF MATERIALS CHEMISTRY, 2001, 11 (02) :231-245
[6]   Optical response of cerium-doped lutetium oxyorthosilicate coatings at shocked surfaces [J].
Stevens, GD ;
Lutz, SS ;
Turley, WD ;
Adams, CD ;
Boat, RM ;
Hull, LM .
REVIEW OF SCIENTIFIC INSTRUMENTS, 2004, 75 (02) :462-466
[7]   Triboluminescence with and without Air [J].
Sweeting, LM .
CHEMISTRY OF MATERIALS, 2001, 13 (03) :854-870
[8]   TRIBOLUMINESCENCE [J].
WALTON, AJ .
ADVANCES IN PHYSICS, 1977, 26 (06) :887-948
[9]  
WOMACK F, 2004, THESIS U LOUISIANA L
[10]   Measurement of triboluminescence and proton half brightness dose for ZnS:Mn [J].
Womack, FN ;
Goedeke, SM ;
Bergeron, NP ;
Hollerman, WA ;
Allison, SW .
IEEE TRANSACTIONS ON NUCLEAR SCIENCE, 2004, 51 (04) :1737-1741