Soil-blade dynamics in reverse-rotational rotary tillage

Soil cutting and the clod crack formation process during reverse-rotational rotary tillage in a heavy clay soil were investigated. Of particular interest was the relationship between clod crack formation and tillage resistance during sequential rotations of the tillage blade. Investigation of the crack formation process is helpful to develop and to design more effective and high performance tillage methods. This paper describes two new discoveries. The first is that the tillage resistance showed a higher cross-correlation between sequential rotations within a certain distance of tilling, while there was little or no cross-correlation between different tillage plots that were separated more than 0.4 m. The forward distance of untilled soil that was disturbed by the tillage blade was estimated to be 36.4 mm. This is the distance of two tillage pitches. The second discovery involved the blade frequencies during tilling. Fluctuation in tillage resistance frequencies of a single blade was nearly equal to the predicted occurrence of crack intervals on the tilled clod's surface. This frequency was 120 Hz. When these frequencies were translated into the distance along the trochoid trajectory of the blade cutting edge, they were the same as the length of the clods tilled by the reverse-rotational rotary tiller. These minute vibrations in the tillage resistance were considered the important indexes for recognizing the tilled soil conditions and the tilled clod failure on the reverse-rotational rotary tiller. The analytical results of this paper will be utilized for the active occurrence of the cracks regarding with natural frequency of the blade and the operation condition of the reverse-rotational rotary tiller. (C) 2002 ISTVS. Published by Elsevier Science Ltd. All rights reserved.