Compressive response of NiTi single crystals

被引:275
作者
Sehitoglu, H
Karaman, I
Anderson, R
Zhang, X
Gall, K
Maier, HJ
Chumlyakov, Y
机构
[1] Univ Illinois, Dept Mech & Ind Engn, Urbana, IL 61801 USA
[2] Univ Colorado, Dept Mech Engn, Boulder, CO 80309 USA
[3] Univ Gesamthsch Paderborn, Lehrstuhl Werkstoffkunde, D-33095 Paderborn, Germany
[4] Siberian Phys Tech Inst, Tomsk 634050, Russia
基金
美国国家科学基金会;
关键词
shape memory; Ni-Ti alloys; single crystal; phase transformations;
D O I
10.1016/S1359-6454(00)00153-1
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The deformation of NiTi shape memory single crystals are reported under compression loading for selected crystal orientations and two different Ti3Ni4 precipitate sizes. For the [148] orientation, selected for highest recoverable strains, the peak aging treatment decreased the transformation stress from austenite to martensite. At the same time, peak aging raised the flow stress of both the austenite and martensite compared to the overaged case by increasing the resistance of the material to dislocation motion. The transformation proceeds beyond the stress plateau region and extends until martensite yielding occurs. This results in recoverable strain levels equivalent to the theoretical estimate of 6.4%. The [112] orientation was chosen to produce two variant formations and in this case, the transformation proceeded over an ascending stress-strain curve compared to the nearly plateau response for the [148] case. Since the austenite and martensite yield levels are reached at a smaller strain level in this case, the maximum recoverable strain was limited to 3.5% even though the theoretical estimates are near 5.1%. The theoretical estimates of transformation strains were established for Type I and Type II twinning cases to cover all possible habit plane and twin systems. TEM investigations support that slip in austenite occurs concomitant with increasing transformation strains. In the [001] orientation, the unfavorable slip systems for dislocation motion in the austenite inhibit slip and permit recoverable strains similar to the theoretical estimates (nearly 4.2%). The [001] orientation exhibits a continuous increase of flow stress with temperature beyond 360 K unlike any other orientation. The results point out that in order to optimize the material performance, close attention must be paid to the selection of the crystallographic orientation, and the precipitate size through heat treatment. (C)2000 Acta Metallurgica Inc. Published by Elsevier Science Ltd. AII rights reserved.
引用
收藏
页码:3311 / 3326
页数:16
相关论文
共 16 条
[1]   FINE PHASE MIXTURES AS MINIMIZERS OF ENERGY [J].
BALL, JM ;
JAMES, RD .
ARCHIVE FOR RATIONAL MECHANICS AND ANALYSIS, 1987, 100 (01) :13-52
[2]  
Bataillard L, 1998, PHILOS MAG A, V78, P327, DOI 10.1080/01418619808241907
[3]   Predicting the orientation-dependent stress-induced transformation and detwinning response of shape memory alloy single crystals [J].
Buchheit, TE ;
Wert, JA .
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 1996, 27 (02) :269-279
[4]  
Chumlyakov Yu. I., 1996, Physics of Metals and Metallography, V82, P102
[5]   The role of texture in tension-compression asymmetry in polycrystalline NiTi [J].
Gall, K ;
Sehitoglu, H .
INTERNATIONAL JOURNAL OF PLASTICITY, 1999, 15 (01) :69-92
[6]   The influence of aging on critical transformation stress levels and martensite start temperatures in NiTi: Part II - Discussion of experimental results [J].
Gall, K ;
Sehitoglu, H ;
Chumlyakov, YI ;
Kireeva, IV ;
Maier, HJ .
JOURNAL OF ENGINEERING MATERIALS AND TECHNOLOGY-TRANSACTIONS OF THE ASME, 1999, 121 (01) :28-37
[7]   The influence of aging on critical transformation stress levels and martensite start temperatures in NiTi: Part I - Aged microstructure and micro-mechanical modeling [J].
Gall, K ;
Sehitoglu, H ;
Chumlyakov, YI ;
Kireeva, IV ;
Maier, HJ .
JOURNAL OF ENGINEERING MATERIALS AND TECHNOLOGY-TRANSACTIONS OF THE ASME, 1999, 121 (01) :19-27
[8]   Tension-compression asymmetry of the stress-strain response in aged single crystal and polycrystalline NiTi [J].
Gall, K ;
Sehitoglu, H ;
Chumlyakov, YI ;
Kireeva, IV .
ACTA MATERIALIA, 1999, 47 (04) :1203-1217
[9]  
Hane KF, 1998, PHILOS MAG A, V78, P1215, DOI 10.1080/01418619808239984
[10]   Effect of texture orientation on the martensite deformation of NiTi shape memory alloy sheet [J].
Liu, Y ;
Xie, ZL ;
Van Humbeeck, J ;
Delaey, L .
ACTA MATERIALIA, 1999, 47 (02) :645-660