Optimal design of composite hood with reinforcing ribs through stiffness analysis

Fiber glass reinforced composites like sheet molding compounds (SMC) have recently been widely used in the fabrication of two-piece automobile hoods for passenger cars. In the present investigation, a one-piece composite hood with reinforcing ribs was optimally designed and manufactured by resin transfer molding in order to reduce manufacturing cost. In order to obtain the optimal design, stiffness analyses for deflections due to self-weight, oil canning, and torsion test conditions were carried out by applying the ABAQUS/Standard program. Based on these analyses, the thickness dimension of the composite hood required to maintain a stiffness comparable to a conventional steel hood was determined. For optimization studies of the weight reduction of the currently proposed one-piece composite hood with reinforcing ribs, IDESIGN program was employed. Based on a recursive quadratic programming technique, the thickness dimensions of the reinforcing ribs were optimized. The deflection ratios between fiber glass reinforced composite and conventional steel hoods were minimized in the optimization studies. From the present studies, it was found that the weight saving effect obtained by introducing the optimally designed one-piece composite hood was 37% compared to the conventional steel hood. This ranged approximately from 30 to 40% for composite hoods manufactured by resin transfer molding, depending on the composite materials used. Through these studies, it was confirmed that the one-piece composite hood was a preferable design and manufacture, compared to currently used composite hood made in two pieces, in terms of weight reductions and manufacturing cast without losing the stiffness required. Copyright (C) 1997 Elsevier Science Ltd.