Flow injection spectrofluorimetric determination of reserpine in tablets by on-line acetone sensitized photochemical reaction

On-line photochemical reaction of reserpine in the presence of acetone was investigated. Acetone was found to speed up the on-line photochemical conversion of reserpine into an intensively fluorescent compound. Not only reaction acidity but also the acetate buffer concentration affected the on-line photochemical induced fluorescence signal. Based on the observation an automated flow injection photochemical fluorimetric approach was developed. An injected sample zone was carried by a water stream to be merged with a acetate buffer (pH 3.4) solution containing 0.02% acetone in a knotted PTFE reactor (KR), which was freely coiled around a 6-W low pressure mercury lamp. While passing the KR, reserpine was transformed into an intensively fluorescent compound. It was on-line detected in a flow-through cell at the emission wavelength of 490 nm and excitation wavelength of 386 nm. At optimized conditions, a detection limit 0.45 mug 1(-1) was achieved at a sampling rate of 90 h(-1). Eleven determinations of a 0.5 mg 1(-1) reserpine standard solution gave a R.S.D. of 0.3%. The linear dynamic range of reserpine calibration curve was 0.01-0.75 mg 1(-1). The proposed method was applied to assay the reserpine content in tablets and to monitor the dissolution profile or reserpine tablets. Satisfactory results were obtained for both the assays and dissolution studies. (C) 2000 Elsevier Science B.V. All rights reserved.